Frequent Stops „Charging Completed“

[nondrun]

Hi all,

I installed the Integration with the blueprint, Running a GoE Gemini Flex 2.0, Firmware 59.4

In principle its all running fine, however im a getting frequent charging stops without apparent reason. I.e. when there is still sufficient surplus available and the car is not fully charged. Following that, the charger usually starts again within a couple of minutes.

The integration receives the correct surplus values as reported from the entity „Power Demo Grid“ / „power to Grid“.

I also don‘t think this is a Connection issue as when e.g. home assistant does not deliver the values the wallbox stops with the message „surplus not availabl“, tried this by interrupting the connection manually.

Any suggesitons where i could look for possible reasons for that behavior?

Thanks!

[marq24]

are you sure, that you send in an interval smaller then 5sec NEW data to the Charger? There is an issue that only if the PV value is changing every 5 seconds, the device will recognise the new data push...

[nondrun]

Hi, I would assume so is there a waz to Check this? i thought the blueprint would do that automaticaly (i.e. refresh the value every 5sec Even in the underlying surplus value Front the source entity might be older the 5 sec?)

Also I just saw that the status entity in the integration shows weird results: “changed to not charging due ‘fallback (electricity price (“geändert zu nicht laden weil ‘fallback (günstiger Strompreis)

The flexible tariffs function is turned off in the app though…

[nondrun]

… according to the history in the surplus charging automation the data is sent every 5sec…